产品中心

产品中心

PRODUCT CENTER
Number of views:
1000

Degassing system

The boiler pulse bag dust remover of FGDM series is the latest technology achievement in Fushi environmental technology research and development center. The device is a unil-combined dust removal equipment with large air volume, good ash removal ffectl and reliable operation. 1n' s widely used tom the gas dust and materials recycle which are produced in bilers, furnaces and waste incineration in power, meallurgy. building. and chemical industries, etc.
Product serial number
Category
Contact Us
1
Product description
Parameters

Working principle

The dust gas enters into the dust hopper of each unit from the guide pipe and the large particles directly falls into the dust hopper after the separation under the guidance of the dust hopper guide system. Other dust gas enters the filtration area of the middle box with the gas flow. The fitered clean gas goes through the filter bag, and is discharged through the upper box, lift valve and exhaust pipe. With the progress of filtration, when the dust concentration on the surface of the filter bag reaches a certain amount, the lfting valve will be closed by the dust removal control device according to the set procedure. Open the electromagnetic pulse valve to blow. Shake off the dust on the filter bag and it falls into the dust hopper through the discharge valve.

This series of dust removers are provided with bypass flues. When the boiler (or incinerator) is started, open the bypass flue to prevent that when there' s poor combustion of oil during ignition, oil sticks to the filter bag and burns the filter bag in case of open fire. Open the bypass when the boiler has an accident and the exhaust temperature exceeds the allowable temperature of the filter bag.

The series of dust removers are also equipped with leakage detection device. It has a number of probes (each warehouse room has 1), and at the same time in the dust hopper, it has an air cannon.

Major parameters

img

We could not find any corresponding parameters, please add them to the properties table
Next

Hotline

0769-82181577